注意报错提示：$ X! h2 L7 q0 \- q: b* f9 {
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
: S/ D; }, o K. v h646.04: Travel action ignored.
0 ?7 X$ f' [+ {3 J( F+ Y646.04: No debugger information is available.* _7 ]! `: d9 r ~) A. Z I& r9 A
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.* l* a$ z9 n8 S
646.04: Travel action ignored.
+ U* U# a4 V1 l646.04: No debugger information is available.4 E% s: C) [& k8 O" r% F
3 G8 x% X2 A) J2 L
回来看代码：
# l% Z9 _0 C" R9 U2 c# C
: j% Y9 |, X* y$ X$ Gbegin P_output1 arriving procedure7 w" P" l o9 o6 p X
travel to Conv.staoutput15 G3 {6 t2 H0 `3 O. Y2 ]
move into Q_output(1) 3 V' @7 ] O3 U7 i' y: n
/*Location to wait for a vehicle*/. y; g7 a& e/ ]3 E ~- I
travel to Rgv.cpoutput1 /*Get on Vehicle*/' e; }* h$ b) R, v7 E( p5 L
send to P_store% q) Q8 c& R- }9 a; }
end ; n% R8 x+ }* X9 y
4 A' f6 z: o) x& ]% ~begin P_store arriving procedure
+ D- A& u% H9 S' v. q travel to Rgv.cpstore
6 @# _" X7 Q: C3 u /* Travel onboard vehicle to cpstore */$ Q5 l5 h+ ^2 V, l- Y5 c* ?
move into Q_store /* Get off vehicle */ K- r& M# m0 m P p
wait for 20 sec
. \5 p5 U) C% {6 b9 t1 ]$ ]. g$ p$ S set A_Time to ac - A_Time
: B& Z% i7 L1 R) g) V# i print this load, "Time in system " A_Time to message4 W8 w; s" N$ v; \
inc V_Numdone by 1$ _5 E5 \# {3 X; n! E$ V' \: S
send to die
( H4 N. k9 p# l) @( S1 \, Nend
& s2 I9 f- V3 s3 m) b; z: C' X. O* v2 E2 f- u* E" o- o
知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
